You must set up new Window Glass in your Ford Explorer if the old glass was cracked in any approach and especially if the window was fully broken and shattered. The glass used in an Explorer is often about 24 by 32 inches for entrance doors and 22 by 24 for rear doors. Test with an auto glass knowledgeable for the exact measurement used for your yr mannequin Explorer. Upon getting the correct glass, it’s essential to open up the door’s trim panel to insert the glass within its regulator.
Ford Explorer Window Glass Installation Instructions
1. Lower the window regulator, whether or not it has the old glass or not, to the bottom of the door. Pry the weatherstrip up and out of the window opening on the automobile door. Seize the strip on the finish near the outer edge of the door (away from the door hinges). Disconnect the unfavorable battery cable.
2. Detach the door’s trim panel. Pry the door handle bezel off with a flat-blade software and remove the armrest switch management, unplugging its electrical connectors. Remove all screws on the trim panel, together with the one which was behind the armrest control. Lift up the panel up off its retaining clips by grabbing it at the swap control opening. Disconnect another electrical connectors.
3. Peel the water defend away from the door. If the Explorer has speakers in the door, remove them and every other screws that are in the way in which of removing the water shield.
4. Take away the outdated glass, or any items of glass, if necessary. Remove the bolts fastening it to the regulator. If the glass is usually intact, elevate it upward and out of the door. If the glass is in shattered pieces, fastidiously take away every bit individually and make sure no shards fall into the door frame.
5. Insert the brand new Window Glass into the door and into the regulator. You possibly can slide it down by means of the door’s window opening, however, if it’s doable, it may be easier to push it up by means of the underside of the door after which back down into the regulator. Bolt the window in place on the regulator.
6. Substitute the water protect and audio system on the door. Reattach the total trim panel in reverse order of removal. Fit the weatherstrip back on the window opening.
